여러분이 우리Juniper JN0-692문제와 답을 체험하는 동시에 우리ITExamDump를 선택여부에 대하여 답이 나올 것입니다. 우리는 백프로 여러분들한테 편리함과 통과 율은 보장 드립니다. 여러분이 안전하게Juniper JN0-692시험을 패스할 수 있는 곳은 바로 ITExamDump입니다.
ITExamDump의 Juniper인증 JN0-692덤프를 구매하시면 1년동안 무료 업데이트서비스버전을 받을수 있습니다. 시험문제가 변경되면 업데이트 하도록 최선을 다하기에ITExamDump의 Juniper인증 JN0-692덤프의 유효기간을 연장시켜드리는 셈입니다.퍼펙트한 구매후는 서비스는ITExamDump의 Juniper인증 JN0-692덤프를 구매하시면 받을수 있습니다.
지금 같은 정보시대에, 많은 IT업체 등 사이트에Juniper JN0-692인증관련 자료들이 제공되고 있습니다, 하지만 이런 사이트들도 정확하고 최신 시험자료 확보는 아주 어렵습니다. 그들의Juniper JN0-692자료들은 아주 기본적인 것들뿐입니다. 전면적이지 못하여 응시자들의 관심을 쌓지 못합니다.
Juniper인증 JN0-692시험은 빨리 패스해야 되는데 어디서부터 어떻게 시험준비를 시작해야 하는지 갈피를 잡을수 없는 분들은ITExamDump가 도와드립니다. ITExamDump의 Juniper인증 JN0-692덤프만 공부하면 시험패스에 자신이 생겨 불안한 상태에서 벗어날수 있습니다.덤프는 시장에서 가장 최신버전이기에 최신 시험문제의 모든 시험범위와 시험유형을 커버하여Juniper인증 JN0-692시험을 쉽게 패스하여 자격증을 취득하여 찬란한 미래에 더 가깝도록 도와드립니다.
여러분은 우선 우리 ITExamDump사이트에서 제공하는Juniper인증JN0-692시험덤프의 일부 문제와 답을 체험해보세요. 우리 ITExamDump를 선택해주신다면 우리는 최선을 다하여 여러분이 꼭 한번에 시험을 패스할 수 있도록 도와드리겠습니다.만약 여러분이 우리의 인증시험덤프를 보시고 시험이랑 틀려서 패스를 하지 못하였다면 우리는 무조건 덤프비용전부를 환불해드립니다.
시험 번호/코드: JN0-692
시험 이름: Juniper (Service Provider Routing and Switching Support, Professional)
당신이 구입하기 전에 시도
일년동안 무료 업데이트
100% 환불보장약속
100% 합격율 보장
Q&A: 171 문항
업데이트: 2014-02-18
한번에Juniper인증JN0-692시험을 패스하고 싶으시다면 완전 페펙트한 준비가 필요합니다. 완벽한 관연 지식터득은 물론입니다. 우리ITExamDump의 자료들은 여러분의 이런 시험준비에 많은 도움이 될 것입니다.
JN0-692 덤프무료샘플다운로드하기: http://www.itexamdump.com/JN0-692.html
NO.1 An OSPF neighbor between routers R1 and R2 is stuck in loading state on R2. What are two
causes? (Choose two.)
A. OSPF is not enabled on the interfaces.
B. A firewall filter is blocking OSPF hellos on both sides.
C. The R1 router has received a corrupted link-state request packet.
D. The interface MTU is mismatched between the routers.
Answer: C,D
Juniper JN0-692 pdf JN0-692 JN0-692
NO.2 One of your router's OSPF adjacencies is down.
What are three reasons for this adjacency state change? (Choose Three)
A. A filter has just been configured on one of the OSPF routers.
B. The OSPF hello value is the same on both routers.
C. The controlling BFD session state has gone down.
D. The authentication key on both routers matches.
E. One of the physical interfaces has gone down.
Answer: A,C,E
Juniper JN0-692 JN0-692자료 JN0-692 JN0-692
NO.3 You have recently added LDP-signaled VPLS to your network. The VPLS connections are
established and you have been asked to verify that the forwarding plane is working properly. Which
three commands would you use? (Choose three.)
A. ping mpls Idp <fec>
B. show vpls connections
C. traceroute mpls Idp <fec>
D. show vpls mac-table
E. show Idp statistics
Answer: A,C,D
Juniper JN0-692 JN0-692 JN0-692 dumps JN0-692
10. R1 and R2 are IS-IS Level 1 routers, but are not forming an adjacency.
Which two reasons would account for this happening? (Choose two.)
A. The remote router is configured for both IPv4 and IPv6.
B. The remote router does not have family iso enabled on its interface,
C. The remote router does not have family clns enabled on its interface.
D. The remote router is not configured to participate in the same Level 1 area
Answer: B,D
Juniper JN0-692 JN0-692자격증 JN0-692 dumps JN0-692 dumps
NO.4 Your OSPF network includes an NSSA. Which LSA type is injected into the NSSA by the ASBR?
A. Type 3
B. Type 5
C. Type 7
D. Type 9
Answer: C
Juniper기출문제 JN0-692 JN0-692 JN0-692기출문제
NO.5 Your currently configured regular expression does not match the AS path shown below:
2135.55 55 55 55 3796
Which three regular expressions would match this path? (Choose three.)
A. "."2135"
B. "2135.*"
C. "* 55(1, 3) *"
D. "2135 55(5) 3796"
E. "2135 55(1, 2) 3796"
Answer: B,C,E
Juniper자료 JN0-692인증 JN0-692 JN0-692
NO.6 You have applied a customized EXP rewrite rule on router R1 on the egress of the interface
connecting to router R2. You want to verify if it is working properly. Which two methods would you
use to accomplish this task? (Choose two.)
A. Apply a rewrite rule on the ingress of R2 for packets coming in from R1 and count those packets
for the new EXP values with a firewall filter as they leave R2.
B. Use the traceroute utility.
C. Use an output filter on R1 that matches and counts on various EXP values on packets going to R2.
D. Use an input firewall filter on R2 that matches and counts on various EXP values on packets
coming from R1.
Answer: C,D
Juniper기출문제 JN0-692 JN0-692인증
NO.7 You have recently implemented a new Layer 2 VPN and it is not establishing. The show I2vpn
connections command displays an out-of-range state.
What is causing this problem?
A. The local site ID value is too high for the label block.
B. The VRF target community values do not match between sites.
C. The VRF route distinguisher values do not match between sites.
D. The local site ID is not defined.
Answer: A
Juniper최신덤프 JN0-692 JN0-692
NO.8 You recently added your autonomous system to an existing BGP confederation. You notice that
a route that had a local preference of 100 now has a local preference of 50. Which statement
explains the change?
A. BGP path attributes such as next hop, local preference, and MED are normally restricted to a
single AS but are allowed to propagate throughout the confederation's AS members.
B. The confederation has sub-ASs that require all IBGP routes to have a local preference of 50 or
below.
C. When your Junos devices joined the confederation, they lost IBGP connectivity to the route in
question; the local preference reverted to 50 once the BGP peering established.
D. The route is being shared through an EBGP peer, and the confederation is propagating the local
preference from the peer.
Answer: A
Juniper시험문제 JN0-692인증 JN0-692 JN0-692 JN0-692
NO.9 You are asked to retain several routes from an external BGP neighbor in the routing table on
your local router, but you are not allowed to forward traffic to these destinations. You have
configured a forwarding table firewall filter to block these routes, and applied it under the (edit
forwarding-options] hierarchy, but the routes are still showing up in the forwarding table. What is
required to achieve this task?
A. Configure an EBGP import policy on your local router to block the routes.
B. Have the EBGP neighbor configure an export policy to block the routes.
C. Configure an export policy for the forwarding table to block the routes.
D. Use the no-install configuration statement within the EBGP neighbor group on your local router.
Answer: C
Juniper JN0-692 JN0-692 JN0-692 JN0-692
ITexamdump의 70-462덤프의 VCE테스트프로그램과 1Y0-A26덤프는 한방에 시험을 패스하도록 도와드립니다. ITexamdump 에서는 최신버전의 642-242시험에 대비한 고품질 덤프와 000-196시험 최신버전덤프를 제공해드립니다. 최고품질 000-781시험자료는 100% 간단하게 시험패스하도록 최선을 다하고 있습니다. IT인증시험패스는 이토록 간단합니다.
댓글 없음:
댓글 쓰기